Pop-Up Box Card cricut

 Pop-up card box base only.  You can cut the base free, then decorate both sides any way you want…the card will fit into a 5 x 7 envelope as is, or can actually go a bit bigger…you could also reduce it to fit an A2 card.

Here is the cricut link… https://design.cricut.com/landing/project-detail/61e74d86e07b7e40d7dcd749

Looks like this on design space. 

To make…glue 4 panels on to the box section, and one panel to each side of the rectangle.  Decorate everything as wanted. Don’t add extra dimension or add too many layers to the pop up panel. (it makes it harder to slide through the slit to mail) … Fold box at score lines, all toward the inside.

 

The bottom two flaps is what you will glue the card panel to.  Don’t glue the flaps together until you put the panel between the pieces.

But it looks like this folded correctly.

Slide the panel in the slit and down even with the inside of the flaps..glue the flaps one to to each side of the card.

This allows the card to slide so you can close the card to mail.

Scrap card SVG

 This is a SVG that I can’t upload…neither blogger or Facebook will allow true SVGs…so, if you want the SVG file, email me or ask in the comments and I’ll send it along…

Here (bottom) is also a png template if you want to cut by hand or separate the pieces to upload on your own.

These are all scraps.  You can use any thing you want as a center piece to make it fit your need.

Make sure to select all and make the panel and pieces fit the size card you want to make…it will stretch to almost any size..I make the back panel 1/2 inch smaller than the card dimensions so there is 1/4” all around.

Tips…glue in the corner pieces first leaving about 1/8th” on the edges, then fit in the other pieces…